Siemens RX1500 User Manual page 543

RUGGEDCOM ROX II
User Guide
Figure 584: Default Information Originate Form
1. Always Advertise Default Route Enable Check Box
6. In the Default Information Originate form, configure the following parameters:
Parameter
Always Advertise Default Route
Metric
Metric Type
Route Map
7. Configure prefix list filters. For more information, refer to
8. Configure areas. For more information, refer to
9. Configure route map filters. For more information, refer to
10. Configure redistribution metrics. For more information, refer to
Metric".
11. Configure interfaces. For more information, refer to
12. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
13. Click Exit Transaction or continue making changes.
Configuring OSPF
1
2
3
4
2. Metric Box
Description
Default: false
Always advertise default route even when there is no default route present in routing
table.
The metric value for default route.
Default: 2
The mtric type for default route.
The route map name.
3. Metric Type Box
Section 5.21.4.3, "Adding a Prefix
Section 5.21.5.2, "Adding an
Section 5.21.6.3, "Adding a Route Map
Section 5.21.8.2, "Adding a Redistribution
Section 5.21.9.2, "Configuring a Routing
Setup and Configuration
4. Route Map List
List".
Area".
Filter".
Interface".
Chapter 5
511