Deleting An Ethernet Trunk Interface; Managing Ethernet Trunk Ports - Siemens RX1500 User Manual

Chapter 3
Device Management
Parameter
9. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
10. Click Exit Transaction or continue making changes.
Section 3.22.3

Deleting an Ethernet Trunk Interface

To delete an Ethernet trunk interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » trunks. The Ethernet Trunk Interfaces table appears.
1
Figure 141: Ethernet Trunk Interfaces Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen trunk.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 3.22.4

Managing Ethernet Trunk Ports

The following sections describe how to configure and manage Ethernet trunk ports:
• Section 3.22.4.1, "Viewing a List of Ethernet Trunk Ports"
• Section 3.22.4.2, "Adding an Ethernet Trunk Port"
138
Description
GVRP (Generic VLAN Registration Protocol) operation on the port. There are several
GVRP operation modes:
• DISABLED : the port is not capable of any GVRP processing.
• ADVERTISE ONLY : the port will declare all VLANs existing in the switch (configured
or learned) but will not learn any VLANs.
• ADVERTISE and LEARN : the port will declare all VLANs existing in the switch
(configured or learned) and can dynamically learn VLANs.
3. Delete Button
2 3
Deleting an Ethernet Trunk Interface
RUGGEDCOM ROX II
User Guide