Enabling/Disabling The Ntp Service - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 293: Network Time Protocol (NTP) Form
1. Enable NTP Service Check Box
3. Select the Enable Broadcast Client check box to enable the broadcast client.
4. Add a broadcast address for a known NTP server. For more information, refer to
a Broadcast/Multicast
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.12.7

Enabling/Disabling the NTP Service

To enable/disable the NTP service, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » time » ntp. The Network Time Protocol (NTP) form appears.
Figure 294: Network Time Protocol (NTP) Form
1. Enable NTP Service Check Box
3. Select the Enable NTP Service check box to enable the NTP service, or clear the check box to disable the
service.
284
1
2
2. Enable Broadcast Client Check Box
Address".
1
2
2. Enable Broadcast Client Check Box
RUGGEDCOM ROX II
User Guide
Section 5.12.12.2, "Adding
Enabling/Disabling the NTP Service