Managing Router Ports; Viewing A List Of Router Ports - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
IGMP Query Interval (s)
Router Forwarding
RSTP Flooding
4. Assign one or more ports for IGMP to use when sending Membership Reports. For more information, refer to
Section 5.25.4.2, "Adding a Router
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.25.4

Managing Router Ports

The following sections describe how to configure and manage router ports used for IGMP snooping:
• Section 5.25.4.1, "Viewing a List of Router Ports"
• Section 5.25.4.2, "Adding a Router Port"
• Section 5.25.4.3, "Deleting a Router Port"
Section 5.25.4.1

Viewing a List of Router Ports

To view a list of router ports used for IGMP snooping, navigate to switch » mcast-filtering » igmp-snooping »
router-ports. If router ports have been configured, the Router Ports table appears.
Figure 663: Router Ports Table
If no router ports have been configured, add ports as needed. For more information, refer to
"Adding a Router Port".
572
Description
• ACTIVE : The switch generates IGMP queries, if no queries from a better candidate
for the querier are detected for a while.
Default: 60
The time interval between IGMP queries generated by the switch. NOTE: This
parameter also affects the Group Membership Interval (i.e. the group subscriber aging
time), therefore, it takes effect even in PASSIVE mode.
Default: true
Whether or not multicast streams will always be forwarded to multicast routers.
Whether or not multicast streams will be flooded out of all Rapid Spanning Tree Protocol
(RSTP) non-edge ports upon detection of a topology change. Such flooding is desirable,
if multicast stream delivery must be guaranteed without interruption.
Port".
RUGGEDCOM ROX II
User Guide
Section 5.25.4.2,
Managing Router Ports