Siemens RX1500 User Manual page 804

Chapter 5
Setup and Configuration
Click Add to create the new traffic control device. The Advanced Traffic Control Interfaces form appears.
4.
Figure 886: Advanced Traffic Control Interfaces Form
1. In Band Width Box
5. Configure the following parameter(s) as required:
Parameter
In Bandwidth
In Units
Out Bandwidth
Out Units
description
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
772
1
2
3
4
5
2. In Unit List 3. Out Bandwidth Box
Description
Default: 0
Incoming bandwidth. Default: 0 = ignore ingress.
Defines the maximum traffic allowed for this interface in total.
If the rate is exceeded, the packets are dropped.
Synopsis: none, kilobits, megabits
Default: none
Unit for inbandwidth, per second.
Maximum outgoing bandwidth... This is the maximum speed that can be
handled. Additional packets will be dropped. This is the
bandwidth that can be refrred-to as 'full' when defining classes.
Synopsis: kilobits, megabits
Default: megabits
Unit for outgoing bandwidth, per second.
A description for this configuration item.
4. Out Unit List 5. Description Box
RUGGEDCOM ROX II
User Guide
Adding a Traffic Control Device