Managing Prefix Lists And Entries; Viewing A List Of Prefix Lists - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 543: Advertised Route Table
The Advertised Route table provides the following information:
Parameter
Network
Type
Sub Type
Nexthop
Metric
From
Tag
Time
If no dynamic RIP routes have been configured, configure RIP and add routes as needed. For more information
about configuring RIP, refer to
Section 5.20.3

Managing Prefix Lists and Entries

Neighbors can be associated with prefix lists, which allow the RIPs daemon to filter incoming or outgoing routes
based on the allow and deny entries in the prefix list.
The following sections describe how to configure and manage prefix lists and entries for dynamic RIP routes:
• Section 5.20.3.1, "Viewing a List of Prefix Lists"
• Section 5.20.3.2, "Viewing a List of Prefix Entries"
• Section 5.20.3.3, "Adding a Prefix List"
• Section 5.20.3.4, "Adding a Prefix Entry"
• Section 5.20.3.5, "Deleting a Prefix List"
• Section 5.20.3.6, "Deleting a Prefix Entry"
Section 5.20.3.1

Viewing a List of Prefix Lists

To view a list of prefix lists for dynamic RIP routes, navigate to one routing » dynamic » rip » filter. If prefix lists
have been configured, the Prefix List table appears.
480
Description
The network.
The route type.
The route sub type.
Next hop.
The metric value.
Where this route comes from.
Tag.
The route update time.
Section 5.20.1, "Configuring RIP".
RUGGEDCOM ROX II
User Guide
Managing Prefix Lists and Entries