Managing Cdma Profiles; Viewing A List Of Cdma Profiles; Adding A Cdma Profile - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
• Section 5.13.1, "Managing CDMA Profiles"
• Section 5.13.2, "Managing GSM Profiles"
Section 5.13.1

Managing CDMA Profiles

CDMA (Code Division Multiple Access) profiles must be configured before 3G EVDO CDMA data is available.
For more information about viewing 3G EVDO CDMA data, refer to
Status for Cellular Modems".
The following sections describe how to configure and manage CDMA profiles:
• Section 5.13.1.1, "Viewing a List of CDMA Profiles"
• Section 5.13.1.2, "Adding a CDMA Profile"
• Section 5.13.1.3, "Deleting a CDMA Profile"
Section 5.13.1.1

Viewing a List of CDMA Profiles

To view a list of CDMA profiles, navigate to global » cellular » profiles » cdma. If profiles have been configured,
the Cellular Network Configuration table appears.
Figure 314: Cellular Network Configuration Table
If no CDMA profiles have been configured, add profiles as needed. For more information, refer to
Section 5.13.1.2, "Adding a CDMA
Section 5.13.1.2

Adding a CDMA Profile

To add a CDMA profile for the celullar modem interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to global » cellular » profiles » cdma and click <Add cdma>. The Key Settings form appears.
Managing CDMA Profiles
Profile".
Section 3.23.5, "Viewing the CDMA Network
Chapter 5
Setup and Configuration
299