Adding A Static Multicast Group Entry; Deleting A Static Multicast Group Entry - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.25.5.2

Adding a Static Multicast Group Entry

To list a static multicast group from another device in the Static Multicast Summary table, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to switch » mcast-filtering » static-mcast-table and click <Add static-mcast-table>. The Key
2.
Settings form appears.
Figure 667: Key Settings Form
1. VLAN ID Box
3. Configure the following parameter(s) as required:
NOTE
Letters in MAC addresses must be lowercase.
Parameter
VLAN ID
MAC Address
4. Add one or more egress ports. For more information, refer to
5. Click Add to create the table entry.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
Section 5.25.5.3

Deleting a Static Multicast Group Entry

To delete a static multicast group from the Static Multicast Summary table, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Adding a Static Multicast Group Entry
1
2
2. MAC Address Box 3. Add Button
Description
The VLAN Identifier of the VLAN upon which the multicast group operates.
The multicast group MAC address in the form 01:xx:xx:xx:xx:xx.
Section 5.25.6.2, "Adding an Egress
Chapter 5
Setup and Configuration
3
Port".
575