Adding An Incoming Route Filter; Deleting An Incoming Route Filter - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.21.7.2

Adding an Incoming Route Filter

To add a route filter for incoming advertised routes, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Make sure a route map has been configured. For more information, refer to
Maps"
3. Navigate to routing » dynamic » ospf » incoming-route-filter and click <Add incoming-route-filter>. The
Key Settings form appears.
Figure 610: Key Settings Form
1. Route Map List
4. Click Add to create the new incoming route filter.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.21.7.3

Deleting an Incoming Route Filter

To delete a route filter configured for incoming advertised routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » ospf » incoming-route-filter. The Incoming Route Filter table appears.
2.
528
1
2. Add Button
RUGGEDCOM ROX II
User Guide
Section 5.21.6, "Managing Route
2
Adding an Incoming Route Filter