Viewing A List Of Traffic Control Classes; Adding A Traffic Control Class - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
NOTE
One traffic control class must be added for each network interface.
NOTE
Type of Service (ToS) is defined by the Internet Engineering Task Force (IETF). For more information
about ToS, refer to
The following sections describe how to configure and manage traffic control classes:
• Section 5.37.4.1, "Viewing a List of Traffic Control Classes"
• Section 5.37.4.2, "Adding a Traffic Control Class"
• Section 5.37.4.3, "Deleting a Traffic Control Class"
Section 5.37.4.1

Viewing a List of Traffic Control Classes

To view a list of traffic control classes, navigate to qos » traffic-control » advanced-configuration » tcclasses.
If classes have been configured, the Advanced Traffic Control Classes table appears.
Figure 879: Advanced Traffic Control Classes Table
If no classes have been configured, add classes as needed. For more information, refer to
"Adding a Traffic Control
Section 5.37.4.2

Adding a Traffic Control Class

To add a new traffic control class, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to qos » traffic-control » advanced-configuration » tcclasses and click <Add tcclasses>. The
Key Settings form appears.
Viewing a List of Traffic Control Classes
RFC 1349 [http://tools.ietf.org/html/rfc1349].
Class".
Chapter 5
Setup and Configuration
Section 5.37.4.2,
765