Adding A Network; Deleting A Network - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
If no networks have been configured, add networks as needed. For more information, refer to
"Adding a Network".
Section 5.19.8.2

Adding a Network

To add a network for the BGP protocol, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » network and click <Add option82>. The Key Settings form
appears.
Figure 526: Key Settings Form
1. Subnet Address/Prefix Box
3. Configure the following parameter(s) as required:
Parameter
Subnet Address/Prefix
4. Click Add to create the network.
5. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 5.19.8.4, "Tracking
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
Section 5.19.8.3

Deleting a Network

To delete a network configured for the BGP protocol, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » bgp » network. The BGP Network table appears.
2.
Adding a Network
1
2. Add Button
Description
IP address/prefix.
Commands".
Chapter 5
Setup and Configuration
Section 5.19.8.2,
2
467