Viewing A List Of Ip Ranges For Subnets; Adding An Ip Range To A Dhcp Subnet - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.15.14.1

Viewing a List of IP Ranges for Subnets

To view a list of IP ranges configured for a DHCP subnet, navigate to services » dhcpserver » subnet »
{name} » options » iprange, where {name} is the name of the subnet. If ranges have been configured, the IP
Range Configuration table appears.
Figure 384: IP Range Configuration Table
If no IP ranges have been configured, add ranges as needed. For more information, refer to
"Adding an IP Range to a DHCP
Section 5.15.14.2

Adding an IP Range to a DHCP Subnet

To add an IP range to a DHCP subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to services » dhcpserver » subnet » {name} » options » iprange, where {name} is the name of
2.
the subnet.
Click <Add iprange>. The Key Settings form appears.
3.
Figure 385: Key Settings Form
1. Start Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter
start
5. Click Add to create the IP range. The IP Range Configuration form appears.
354
Subnet".
1
Description
The starting IP address pool that the server uses to offer to the client.
RUGGEDCOM ROX II
Section 5.15.14.2,
2
Viewing a List of IP Ranges for Subnets
User Guide