Managing Snmp Communities; Viewing A List Of Snmp Communities; Adding An Snmp Community - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.11.5

Managing SNMP Communities

The following sections describe how to configure and manage SNMP communities:
• Section 5.11.5.1, "Viewing a List of SNMP Communities"
• Section 5.11.5.2, "Adding an SNMP Community"
• Section 5.11.5.3, "Deleting an SNMP Community"
Section 5.11.5.1

Viewing a List of SNMP Communities

To view a list of SNMP communities configured on the device, navigate to admin » snmp » snmp-community.
The SNMPv1/v2c Community Configuration table appears.
Figure 268: SNMPv1/v2c Community Configuration Table
By default, private and public communities are pre-configured. If additional communities are required, add them
as needed. For more information, refer to
Section 5.11.5.2

Adding an SNMP Community

To add an SNMP community, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-community and click <Add snmp-community>. The Key Settings
form appears.
Managing SNMP Communities
Section 5.11.5.2, "Adding an SNMP
Setup and Configuration
Community".
Chapter 5
263