Viewing A List Of Route Map Filter Entries; Adding A Route Map Filter - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 598: Route Map Table
If no filters have been configured, add filters as needed. For more information, refer to
a Route Map Filter".
Section 5.21.6.2

Viewing a List of Route Map Filter Entries

To view a list of entries for a route map filter for either OSPF, navigate to routing » dynamic » ospf » filter »
route-map » {tag} » entry, where {tag} is the tag for the route map filter. If entries have been configured, the
Route Map Entry table appears.
Figure 599: Route Map Entry Table
If no filters have been configured, add filters as needed. For more information, refer to
a Route Map Filter
Section 5.21.6.3

Adding a Route Map Filter

To add a route map filter for dynamic OSPF routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » ospf » filter » route-map and click <Add route-map>. The Key Settings
form appears.
Viewing a List of Route Map Filter Entries
Entry".
Chapter 5
Setup and Configuration
Section 5.21.6.3, "Adding
Section 5.21.6.4, "Adding
521