Viewing A List Of Link Failover Parameters; Adding A Link Failover Parameter - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.27.3.1

Viewing a List of Link Failover Parameters

To view a list of link failover parameters, navigate to services » link-failover. If parameters have been
configured, the Link Failover Information table appears.
Figure 703: Link Failover Information Table
If no parameters have been configured, add parameters as needed. For more information, refer to
Section 5.27.3.2, "Adding a Link Failover
Section 5.27.3.2

Adding a Link Failover Parameter

To add a link failover parameter, do the following:
NOTE
The link failover feature can only be configured on a routable interface. For the link failover feature to
be used on a switched port, another VLAN must be configured (for example, switch.0002) to logically
differentiate the switched port from the default PVID VLAN 1 (switch.0001).
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » link-failover and click <Add link-failover>. The Key Settings form appears.
Figure 704: Key Settings Form
1. Main List 2. Add Button
3. Select the main interface from the list.
4. Click Add to add the main interface. The Link Fail Over Settings form appears.
Viewing a List of Link Failover Parameters
Parameter".
Chapter 5
Setup and Configuration
603