Siemens RX1500 User Manual page 795

RUGGEDCOM ROX II
User Guide
Figure 877: Basic Traffic Control Priorities Form
1. Band List 2. Protocol Box
5. Configure the following parameter(s) as required:
Parameter
band
protocol
port
address
interface
Adding a Traffic Control Priority
1
2
3
4
5
6
3. Port Box 4. Address Box
Description
Synopsis: high, medium, low
Default: medium
Priority (band) : high, medium, low... High band includes: Minimize Delay (md) (0x10),
md + Minimize Monetary Cost (mmc) (0x12), md + Maximize Reliability (mr) (0x14),
mmc+md+mr (0x16). Medium band includes: Normal Service (0x0), mr (0x04), mmc
+mr (0x06), md + Maximize Throughput (mt) (0x18), mmc+mt+md (0x1a), mr+mt+md
(0x1c), mmc+mr+mt+md (0x1e). Low band includes: mmc (0x02), mt (0x08), mmc+mt
(0x0a), mr+mt (0x0c), mmc+mr+mt (0x0e).
Synopsis: tcp, udp, icmp, all
(choice) A targeted protocol.
(choice) Source port - can be specified only if protocol is TCP, UDP, DCCP, SCTP or
UDPlite
Prerequisite: A port number can be specified only when the protocol is either TCP,
UDP, DCCP, SCTP or UDPlite
(choice) The source address. This can be specified only if the protocol, port and
interface are not defined.
Prerequisite: An address can be specified only if neither a protocol or port nor an
interface are specified.
(choice) The source interface. This can be specified only if the protocol, port and
address are not defined. Lowercase alphanumerical as well as '.' and '-' characters are
allowed.
5. Interface Box 6. Description Box
Chapter 5
Setup and Configuration
763