Siemens RX1500 User Manual page 777

RUGGEDCOM ROX II
User Guide
Figure 859: Key Settings Form
1. VLAN ID Box
4. Configure the following parameter(s) as required:
Parameter
VLAN ID
5. Click Add to create the new VLAN ID. The VLANs form appears.
Figure 860: VLANs Form
1. IP Address Source Box
6. Configure the following parameter(s) as required:
Parameter
IP Address Source
on-demand
7. Add a QoS map for the VLAN. For more information, refer to
8. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
Adding a VLAN ID to a Routable Ethernet Port or Virtual
Switch
1
2. Add Button
Description
The VLAN ID for this routable logical interface.
1
2
2. On-Demand Check Box
Description
Synopsis: static, dynamic
Default: static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. The
DYNAMIC option is a common case of a dynamically assigned IP address. It switches
between BOOTP and DHCP until it gets the response from the relevant server. It must
be static for non-management interfaces.
This interface is up or down on the demand of the link failover.
Section 5.37.7.2, "Adding a QoS
Chapter 5
Setup and Configuration
2
Map".
745