Configuring The Dhcp Server; Enabling/Disabling The Dhcp Server - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
• Section 5.15.3, "Enabling/Disabling the DHCP Relay Support"
• Section 5.15.4, "Viewing a List of Active Leases"
• Section 5.15.5, "Managing DHCP Listen Interfaces"
• Section 5.15.6, "Managing Shared Networks"
• Section 5.15.7, "Managing Subnets"
• Section 5.15.8, "Managing Custom Client Options for Subnets"
• Section 5.15.9, "Managing Hosts"
• Section 5.15.10, "Managing Custom Host Client Configurations"
• Section 5.15.11, "Managing Host Groups"
• Section 5.15.12, "Managing Custom Host Group Client Configurations"
• Section 5.15.13, "Managing IP Pools"
• Section 5.15.14, "Managing IP Ranges for Subnets"
• Section 5.15.15, "Managing IP Ranges for IP Pools"
• Section 5.15.16, "Managing Option 82 Classes for IP Pools"
Section 5.15.1

Configuring the DHCP Server

To configure the DHCP server, do the following:
1. Enable the DHCP Server. For more information, refer to
Server".
2. Add and configure DHCP listen interfaces. For more information, refer to
Listen Interface".
3. Add and configure shared networks. For more information, refer to
Network".
NOTE
At least one shared network must be available before a subnet is added.
4. Add and configure subnets. For more information, refer to
5. Add and configure hosts. For more information, refer to
6. Add and configure host-groups. For more information, refer to
Section 5.15.2

Enabling/Disabling the DHCP Server

To enable or disable the DHCP server, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver. The Dynamic Host Control Protocol (DHCP) server form appears.
Configuring the DHCP Server
Section 5.15.2, "Enabling/Disabling the DHCP
Section 5.15.5.2, "Adding a DHCP
Section 5.15.6.2, "Adding a Shared
Section 5.15.7.2, "Adding a
Section 5.15.9.2, "Adding a
Section 5.15.11.2, "Adding a Host
Chapter 5
Setup and Configuration
Subnet".
Host".
Group".
311