Viewing The Status Of Dynamic Ospf Routes; Managing Prefix Lists And Entries - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.21.3

Viewing the Status of Dynamic OSPF Routes

To view the status of the dynamic OSPF routes configured on the device, navigate to routing » status » ospf »
route » network. If OSPF routes have been configured, the Network table appears.
Figure 585: Network Table
The Network table provides the following information:
Parameter
id
discard
inter-area
cost
area
If no dynamic OSPF routes have been configured, configure OSPF and add routes as needed. For more
information about configuring OSPF, refer to
Section 5.21.4

Managing Prefix Lists and Entries

Neighbors can be associated with prefix lists, which allow the OSPF daemon to filter incoming or outgoing routes
based on the allow and deny entries in the prefix list.
The following sections describe how to configure and manage prefix lists and entries for dynamic OSPF routes:
• Section 5.21.4.1, "Viewing a List of Prefix Lists"
• Section 5.21.4.2, "Viewing a List of Prefix Entries"
• Section 5.21.4.3, "Adding a Prefix List"
• Section 5.21.4.4, "Adding a Prefix Entry"
• Section 5.21.4.5, "Deleting a Prefix List"
• Section 5.21.4.6, "Deleting a Prefix Entry"
512
Description
Network Prefix.
This entry is discarded entry.
Is path type inter area.
Cost.
Area.
Section 5.21.2, "Configuring OSPF".
Viewing the Status of Dynamic OSPF Routes
RUGGEDCOM ROX II
User Guide