Deleting A Broadcast/Multicast Address - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 304: NTP Broadcast/Multicast Servers Form
1. Enable Check Box
6. Configure the following parameter(s) as required:
Parameter
Enable
Key
NTP Version
Time To Live
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.12.12.3

Deleting a Broadcast/Multicast Address

To delete a broadcast/multicast address for an NTP server, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » time » ntp » broadcast. The NTP Broadcast/Multicast Servers table appears.
292
1
2
3
4
2. Key List 3. NTP Version Box
Description
Enables sending broadcast or multicast NTP messages to this address.
Authentication key.
The version of the NTP protocol used to communicate with this host. Change this only if
it is known that the host requires a version other than 4.
Default: 1
Time to live.
4. Time to Live Box
RUGGEDCOM ROX II
Deleting a Broadcast/Multicast Address
User Guide