Viewing A List Of Redistribution Metrics; Adding A Redistribution Metric - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
external metric. This puts external metrics in the range of 64 to 128, even though the metric value defined is only
in the range of 0 to 63.
There is no default metric for IS-IS. A metric should be defined for each routing protocol, otherwise a metric value
of zero (0) is automatically applied.
The following sections describe how to configure and manage redistribution metrics for IS-IS:
• Section 5.18.11.1, "Viewing a List of Redistribution Metrics"
• Section 5.18.11.2, "Adding a Redistribution Metric"
• Section 5.18.11.3, "Deleting a Redistribution Metric"
Section 5.18.11.1

Viewing a List of Redistribution Metrics

To view a list of redistribution metrics defined for an IS-IS area, navigate to routing » dynamic » isis » area »
{name} » redistribute, where {name} is the unique name for the area. The Redistribute table appears.
Figure 478: Redistribute Table
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.18.11.2, "Adding a Redistribution
Section 5.18.11.2

Adding a Redistribution Metric

To add a redistribution metric for an IS-IS area, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » isis » area » {name} » redistribute, where {name} is the unique name for
the area.
3. Click <Add redistribute>. The Key Settings form appears.
Viewing a List of Redistribution Metrics
Metric".
Chapter 5
Setup and Configuration
433