Siemens RX1500 User Manual page 744

Chapter 5
Setup and Configuration
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to interface » trunks » {id} » spanning-tree, where {id} is the ID given to the interface. The
Spanning Tree form appears.
Figure 824: Spanning Tree Form
1. Enabled Check Box
6. RSTP Priority List
Box
3. Configure the following parameters as required:
Parameter
Enabled
Admin Edge
712
1
2
3
4
5
6
7
8
2. Admin Edge List 3. Admin Point-to-Point List
7. STP Cost Box 8. RSTP Cost Box
Description
Default: true
When the box is checked, the Spanning Tree Protocol is enabled on the interface.
Enabling STP activates the STP or RSTP protocol for this interface per the configuration
in the STP Configuration menu.
Synopsis: forceTrue, forceFalse, auto
Default: auto
4. Restricted Role Check Box
Configuring STP for Ethernet Trunk Interfaces
RUGGEDCOM ROX II
User Guide
5. Restricted TCN Check