Viewing A List Of Ldp Interfaces; Enabling/Disabling An Ldp Interface - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.39.7.8

Viewing a List of LDP Interfaces

To view a list of LDP interfaces, navigate to mpls » ldp » interface-ldp. If IP interfaces have been configured, the
LDP Interface List Configuration table appears.
Figure 946: LDP Interface List Configuration Table
For more information about enabling LDP interfaces, refer to
Interface".
Section 5.39.7.9

Enabling/Disabling an LDP Interface

To enable or disable an LDP interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to mpls » ldp » interface-ldp » interface where interface is the name of the interface to be
2.
enabled or disabled for LDP. The LDP Interface List Configuration form appears.
Figure 947: LDP Interface List Configuration Form
1. Enable Check Box
3. Configure the following parameter(s) as required:
Parameter
Enabled
818
1
2
2. Transport IP Address Box
Description
Default: false
A boolean flag to indicate a transport interface is LDP-enabled or not. Only LDP-enabled
interfaces are used for LDP.
Section 5.39.7.9, "Enabling/Disabling an LDP
Viewing a List of LDP Interfaces
RUGGEDCOM ROX II
User Guide