Power:inrush:exit - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:INRush:EXIT

Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also
•
•
548
(see page 1138)
":POWer:INRush:APPLy"
":POWer:INRush:NEXT"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 547
on page 549