Java Vm Updating Procedure - Ricoh D104 Field Service Manual

5. System Maintenance
Module mismatch – Module on
35
SD card is not for this machine
Cannot write module – Cause
36
other than E34, E35
40 Engine module download failed
Operation panel module
42
download failed
Stamp data module download
43
failed
5
Controller module download
44
failed
49 Firmware update is prohibited
Electronic confirmation check
50
failed

Java VM Updating Procedure

1. Turn the main power off, then remove the SD slot cover (
SD slot 2.
2. Insert the Java VM card to the SD card writer that is connected to PC.
3. Make sure which drive is assigned for the SD card.
4. Decompress the downloaded update file, then two files exist that one file is ".exe" file extension and
the other is ".bat" file extension.
5. Double click the ".bat" file then command prompt screen is appeared.
6. The first command line is shown as
"Please input drive letter of SD card [a – x]:"
Then enter the SD card drive name, and press "Enter" key.
536
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
Replace the update data for the module on the SD card
and try again, or replace the BCU board.
Replace the update data for the module on the SD card
and try again, or replace the LCDC.
Replace the update data for the module on the SD card
and try again, or replace the hard disks.
Replace the update data for the module on the SD card
and tray again, or replace controller board.
Set the setting of "Update Firmware" under the
"Administrator Tools" to "Do not Prohibit".
(Administrator Tools > Extended Security > Update
Firmware)
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
x 1), and remove the Java VM card from