Ricoh D104 Field Service Manual page 775

Temp:Other.Center2:LowSpee
021
d
022 Temp:Other:End2:LowSpeed
023 Temp:Envelop:Center1
024 Temp:Envelop:End1
025 Temp:Envelop:Center2
026 Temp:Envelop:End2
1121 [Switch:Rotation Start/Stop]
001 Time:After Reload
Specifies the interval of the re-load mode.
DFU
-002
The following SPs below are desgined for the factory use only. Do not change the adjusted
to -010
setting.
002 Time:After Recovery
003 Time:After Job
004 Press Temp.:After Reload
005 End Uniform Start Temp.:B4
006 End Uniform Start Temp.:B5
007 End Uniform Start Temp.:A5
008 Overshoot Prevent Temp.
009 Overshoot Prevent Time
010 Overshoot Prevent Temp.:End *ENG
[Standby Rotation Setting] DFU
1122
The following SPs below are desgined for the factory use only. Do not change the adjusted
setting.
001 Rotation Interval
*ENG [-35 to 35 / 20 / 1°C/step]
*ENG [-35 to 35 / 20 / 1°C/step]
*ENG [-35 to 35 / 15 / 1°C/step]
*ENG [-35 to 35 / 15 / 1°C/step]
*ENG [-35 to 35 /15 / 1°C/step]
*ENG [-35 to 35 / 15 / 1°C/step]
*ENG [0 to 100 / 100 / 1 sec./step]
*ENG [0 to 100 / 10 / 1 sec./step]
*ENG [0 to 100 / 10 / 1 sec./step]
*ENG [0 to 160 / 160 / 1°C/step]
*ENG [0 to 250 / 200 / 1°C/step]
*ENG [0 to 250 / 200 / 1°C /step]
*ENG [0 to 250 / 190 / 1°C /step]
*ENG [0 to 250 / 200 / 1°C /step]
*ENG [0 to 100 / 10 / 1 sec./step]
[0 to 250 / 200 / 1°C /step]
*ENG [0 to 240 / 60 / 1 min./step]
System SP1-xxx
3
57