4. Replacement and Adjustment
4
• There is a rim [A] at each edge of the transfer belt. The ends of all the rollers ([B] for example) in the
transfer belt unit must be between the two rims.
• There are two rims (width [C]: about 5 mm) at the front and rear edges inside the image transfer
belt.
• This belt must be installed the correct way around. When you reinstall the image transfer belt unit,
install it with the white mark [A] on the belt at the rear side of the unit.
ITB Contact Motor
1. Pull out all the toner bottles.
2. Inverter tray (
3. Inner tray (
222
p.174)
p.175)