Ricoh D104 Field Service Manual page 679

7. Pull the end fence stopper [A], and then tighten the screw.
8. Make sure that the end fence is firmly fixed.
Jam 8: Paper is not fed from the by-pass tray.
1. Remove the paper from the trays 1 and 2.
2. Open the duplex unit.
3. Turn on the paper feed motor on using SP5-804-001 (Output check: Paper Feed M2:CW:190mm/
s).
4. Press the surface of the vertical transport roller [A] for the tray 1 gently with a small piece of paper,
as shown above.
Troubleshooting Guide
6
677