Ricoh D104 Field Service Manual page 132

2. Installation
• Make sure that the edge of the tube [A] is placed as shown above.
• The clamp [B] is not used.
12. Reinstall the harness guide.
13. Reattach the rear cover of the paper feed unit (
2
14. Remove the connector cap [A] from the tray heater harness.
15. Connect the relay harness [B] to the tray heater harness [C] of the mainframe.
• Do not connect the relay harness [B] to the tray heater harness of the mainframe before installing
the securing bracket [D]. Otherwise, the securing bracket may pinch the relay harness.
16. Clamp the harness [A] as shown above (
17. Reinstall the rear lower cover of the mainframe (
18. Reinstall all the tray cassettes.
130
x 2) and securing brackets (
x 1).
x 5).
x 1 each).