Ricoh D104 Field Service Manual page 191

1. Position the center ball [A] in the middle of the forked holder.
2. Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the ring) through
the notch.
3. Wind the right end counterclockwise (shown from the machine's front) five times. Wind the left end
clockwise three times.
• The two green marks [C] come together when you have done this. Stick the wire to the pulley
with tape. This lets you easily handle the assembly at the time of installation.
4. Install the drive pulley on the shaft [A] (
• Do not attach the pulley to the shaft with the screw at this time.
5. Insert the left end into the slit [B]. The end should go via the rear track of the left pulley [C] and the
rear track of the movable pulley [D].
x 1, x 1).
Scanner Unit
4
189