Setting Up The Machine And Your Pc; Firmware Updating Procedure - Ricoh G157 Service Manual

Setting up the machine and your PC

1. Plug the power cord of the machine into a wall socket, and turn on the power
switch while pressing the "5" key on the machine's control panel.
2. Check to see that the pattern shown at
the right shows on the LCD. If it does
not, go back to step 1.
3. Turn on your PC.

Firmware updating procedure

1. Make a folder in your PC, and then copy the firmware to a folder.
2. Use the command prompt or MS-DOS prompt.
3. Change the current directory to the folder that has the firmware.
• For example, the folder that has the firmware is in "C:/temp>".
4. Input the following command to transfer the firmware to the copier.
• C:/temp> copy /B xxxxxx.upd lpt1:
• "xxxxxx" indicates the firmware filename.
5. Beep sound continues to sound during the data transmission.
6. The LCD display changes after completing the data transmission.
7. Turn the main power switch OFF and ON.
Important
• For Europe, Asia or Asia models, a destination code must be set with "EEPROM
Customizing (Function mode 74)" in the service mode.
8. To show the current firmware version on the LCD, hold down the "
keys at the same time when the machine is in the ready condition.
9. Check if the firmware is updated correctly.
SM
CÓPIA NÃO CONTROLADA
5-91
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE
G157S911.WMF
" and " "
G157