• Do not use a dry cloth. Otherwise, the ID sensors may get more dirty due to static electricity.
After installing a new ID sensor unit/board
Do the following adjustment after installing a new ID sensor unit/board.
1. Plug in and turn on the main power switch of the copier.
2. Enter the SP mode.
3. Input all correction coefficients [A] for the ID sensor with the SP modes referring to the barcode sheet
provided with the new ID sensor unit/board.
• For example, input "0.98" with SP3-362-013.
4. Exit the SP mode.
PTR Contact Motor
1. Open the duplex unit.
2. Open the paper transfer unit (
3. Inner right cover (
4. Inner cover (
p.172)
p.225 "PTR (Paper Transfer Roller) Unit").
p.171)
Paper Transfer
4
229