4. Replacement and Adjustment
Run the cable so there is no slack. Slide the adjustor clamp [A] to adjust the cable slack.
• [B]: Good
• [C]: Not good
Scanner Motor
1. Rear cover (
4
2. Scanner motor assembly [A] (
3. Scanner motor [A] (
• Make sure that the ground plate [B] is attached when installing the scanner motor in the scanner
motor bracket.
• Do the scanner image adjustment after replacing the scanner motor (
Adjustment").
182
p.168)
x 2, spring x 1,
x 2, ground plate [B] x 1)
x 1, timing belt x 1)
p.155 "Image