2. Installation
Installing the Punch and Inverter Unit
2
1. Install the punch and inverter unit [A] in the mainframe.
2. Insert the two joint pins [A] (this picture does not show the two joint pins) into the two holes in the inner
rear bracket.
3. Fully attach the front side [B] of the inverter unit to the paper exit unit of the mainframe after inserting
two joint pins (
• Insert the two joint pins before attaching the front side of the inverter unit to the paper exit unit of
the mainframe. Otherwise, paper jams may occur between the paper exit unit and inverter unit.
94
x 1: M3x6).