Postscript 3 - Ricoh D104 Field Service Manual

2. Installation
10. Turn the main switch on.
11. Check that the application programs run normally.
Undo Exec
"Undo Exec" (SP5-873-002) lets you copy back application programs from an SD card to the original SD
2
card. You can use this program when, for example, you have mistakenly copied some programs by using
Move Exec (SP5-873-001).
• Do not turn ON the write protect switch of the system SD card or application SD card on the machine.
If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a firmware
upgrade or application merge.
1. Turn the main switch off.
2. Insert the original SD card in SD Card Slot 2. The application program is copied back into this card.
3. Insert the SD card with the application program in SD Card Slot 1.The application program is copied
back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2.
• This step assumes that the application programs in the SD card are used by the machine.
10. Turn the main switch on.
11. Check that the application programs run normally.
12. Make sure that the machine can recognize the option (see "Check All Connections" at the end of this
section).

PostScript 3

• The PostScript3 application and fonts cannot be moved to another SD card. However, other
applications can be moved onto the PostScript3 SD card.
134