Ricoh D104 Field Service Manual page 781

Htg Roller:Ctr Diff2
151
SPs from -151 to -157 show previous fusing SC information.
154 Htg Roller:End Diff2
155 Htg Roller:End Det2
156 Htg Roller:End Corr2
157 Press Roller Temp Value2
158 Press Roller:End Temp Value2
Htg Roller:Ctr Diff3
201
SPs from -201 to -207 show fusing SC information before previous fusing SC.
204 Htg Roller:End Diff3
205 Htg Roller:End Det3
206 Htg Roller:End Corr3
207 Press Roller Temp Value3
208 Press Roller.End Temp Value3
[Fusing Jam Detection]
1142 DFU
This SP is desgined for the factory use only. Do not change the adjusted setting.
SC Display
001
Enables or disables the fusing consecutive jam (three times) SC detection.
[Fusing Nip Band Check]
DFU
1152
The following SPs below are desgined for the factory use only. Do not change the adjusted
setting.
*ENG [-200 to 260 / - / 1 deg/step]
*ENG
*ENG
*ENG [-10 to 260 / - / 1 deg/step]
*ENG
*ENG
*ENG [-20 to 260 / - / 1 deg/step]
*ENG
*ENG
*ENG [-10 to 260 / - / 1 deg/step]
*ENG
*ENG
[0 or 1 / 0 / -]
*ENG
0: ON, 1: OFF
System SP1-xxx
3
63