Ricoh D104 Field Service Manual page 755

Rotation Time:BW:Hot
027
Specifies the threshold time for the fusing unit heating in black and white mode when the
fusing unit is determined as hot state.
030 Flicker Control
Temp.:Delta:Cold:
101
BW2:Center
102 Temp.:Delta:Cold: BW2:End
103 Temp.:Delta:Cold: BW2:Press
104 Rotation Time: BW2:Cold
Temp.:Delta:Warm:
105
BW2:Center
Temp.:Delta:Warm:
106
BW2:End
Temp.:Delta:Warm:
107
BW2:Press
108 Rotation Time: BW2:Warm
Temp.:Delta:Hot:
109
BW2:Center
110 Temp.:Delta:Hot: BW2:End
111 Temp.:Delta:Hot: BW2:Press
112 Rotation Time: BW2:Hot
[Feed Permit Setting]
1102
Specified the settings of the paper feeding timing.
Destination: NA; North America, TWN; Taiwan, EU; Europe, AA; Asia Pasific
-001 DFU
to -005 These SPs are desgined for the factory use only. Do not change the adjusted setting.
001 Temp.:Lower Delta:Center
002 Temp.:Lower Delta:End
*ENG [0 to 200 / 2 / 1 sec/step]
*ENG [0 or 1 / 0 / -]
*ENG [0 to 100 / NA: 20, EU/AA: 15 / 1 deg/step]
*ENG [0 to 100 / NA: 55, EU/AA: 45 / 1 deg/step]
*ENG [0 to 200 / 0 / 1 deg/step]
*ENG [0 to 200 / 2 / 1 sec/step]
*ENG [0 to 100 / 10 / 1 deg/step]
*ENG [0 to 100 / 45 / 1 deg/step]
*ENG [0 to 200 / 55 / 1 deg/step]
*ENG [0 to 200 / 2 / 1 sec/step]
*ENG [0 to 100 / 10 / 1 deg/step]
*ENG [0 to 100 / 45 / 1 deg/step]
*ENG [0 to 200 / 55 / 1 deg/step]
*ENG [0 to 200 / 2 / 1 sec/step]
*ENG [0 to 100 / NA: 30, EU/AA: 20 / 1 deg/step]
*ENG [0 to 100 / NA: 65, EU/AA: 50 / 1 deg/step]
System SP1-xxx
3
37