Ricoh D104 Field Service Manual page 757

019 Feed Permit Time
Temp.:Lower
020
Delta:Center:Sp.3
021 Temp.:Lower Delta:End:Sp.3
Temp.:Upper
022
Delta:Center:Sp.3
023 Temp.:Upper Delta:End:Sp.3
024 Temp.:Lower Delta:Press:Sp.3
Rotation Time:Sp3
025
Usage Limitation:
Use 3 seconds or more for this setting.
1105 [Print Target Temp]
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Destination: NA; North America, TWN; Taiwan, EU; Europe, AA; Asia Pasific
Plain1:FC:Center
001
Specifies the heating roller target temperature for the ready condition in full color printing.
Usage Limitation:
+5°C against the default value for each destination is the upper limit for this setting.
Plain1:FC:Press (DFU)
Specifies the pressure roller target temperature for the ready condition in full color printing.
002
DFU:
This SP is desgined for the factory use only. Do not change the adjusted setting.
*ENG [0 to 200 / 60 / 1 sec/step]
*ENG [0 to 100 / 25 / 1 deg/step]
*ENG [0 to 100 / 25 / 1 deg/step]
*ENG [0 to 50 / 10 / 1 deg/step]
*ENG [0 to 50 / 10 / 1 deg/step]
*ENG [0 to 200 / 30 / 1 deg/step]
*ENG [0 to 200 / 3 / 1 sec/step]
[100 to 160 / NA: 150, EU/AA: 141 / 1 deg/
*ENG
step]
*ENG [0 to 200 / 95 / 1 deg/step]
System SP1-xxx
3
39