Ricoh D104 Field Service Manual page 869

001 Paper Transfer
[SP 6: Sw Timing: T-Edge] DFU
2898
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge plate at the
paper trailing edge between the erase margin area and the image area.
001 Paper Transfer
2899 [SP 6: Env. Correct Table] DFU
003 Paper Transfer:BW: 1st
005 Paper Transfer:FC: 1st
[Drum Idling Time]
2900
Specifies the drum idling time at job end for each line speed.
001 Normal Speed
002 Low Speed
[Fus.Reload:DrumIdleTimeOffset] DFU
2901
Adjusts the drum idling time for each coverage at the re-load temperature in the half speed
mode.
001 Coverage:0-6%
002 Coverage:6-10%
003 Coverage:10-20%
004 Coverage:20-40%
005 Coverage:40%over
[OPC Drum Rev Time] DFU
2902
Adjusts the time for how long the drum motor reverses after job end.
001 All: BW
002 All: FC
*ENG [0 to 400 / 100 / 5%/step]
*ENG [-98 to 0 / 0 / 2 mm/step]
*ENG [1 to 50 / 17 / 1 /step]
*ENG [1 to 50 / 29 / 1 /step]
*ENG [0 to 60 / 5 / 1sec /step]
*ENG [0 to 120 / 5 / 1sec /step]
*ENG [-60 to 300 / 0 / 1 sec/step]
*ENG [-60 to 300 / 0 / 1 sec/step]
*ENG [-60 to 300 / 0 / 1 sec/step]
*ENG [-60 to 300 / 0 / 1 sec/step]
*ENG [-60 to 300 / 0 / 1 sec/step]
*ENG [0 to 200 / 60 / 10 msec/step]
*ENG [0 to 200 / 50 / 10 msec/step]
System SP2xxx
3
151