Ricoh D104 Field Service Manual page 752

3. Appendix: SP Mode Tables
1007 [By-Pass Size Detection] By-Pass Size Detection Display
0:LT SEF/ 1:LG
Enables or disables the automatic paper size detection function of the by-pass tray.
001
This SP determines what paper size the machine detects if the detected size is less than 8.5".
0: LT SEF (default), 1: LG
[Reload Permit Setting] DFU
3
Specifies the settings of the reload permit for cold temperature in color mode. However, these
1101
SPs are desgined for the factory use only. Do not change the adjusted setting.
Destination: NA; North America, TWN; Taiwan, EU; Europe, AA; Asia Pasific
Pre-rotation Start Temp.
001
Specifies the pre-rotation start temperature.
Reload Target Temp.:Center
002
Specifies the reload target temperature of the heating roller.
Reload Target Temp.:Press
003
Specifies the reload target temperature of the pressure roller.
Temp.:Delta:Cold: Center
004
Specifies the temperature correction of the heating roller (center) when the fusing unit is
determined as cold state.
Temp.:Delta:Cold:End
005
Specifies the temperature correction of the heating roller (end) when the fusing unit is
determined as cold state.
Temp.:Delta:Cold: Press
006
Specifies the temperature correction of the pressure roller when the fusing unit is determined
as cold state.
Rotation Time:Cold
007
Specifies the threshold time for the fusing reload when the fusing unit is determined as cold
state.
34
*ENG -
*ENG [0 to 75 / 50 / 1 deg/step]
*ENG [135 to 145 / 135 / 1 deg/step]
*ENG [0 to 200 / 75 / 1 deg/step]
*ENG [0 to 100 / 20 / 1 deg/step]
*ENG [0 to 100 / NA: 55, EU/AA: 45 / 1 deg/step]
*ENG [0 to 100 / 0 / 1 deg/step]
*ENG [0 to 200 / 2 / 1 sec/step]