Ricoh D104 Field Service Manual page 127

9. Insert the heater harness [A] into the tube [B], and push the tube against the rear frame of the paper
feed unit as shown above.
• Make sure that the tube is in contact with the rear frame [C].
10. Route the relay harness [A] as shown above (
• Make sure that the connector [A] is placed securely as shown above.
• Make sure that the edge of the tube [B] is placed as shown above.
11. Reattach the rear cover of the paper feed unit (
x 5).
x 2) and securing brackets (
Tray Heater
2
x 1 each)
125