Ricoh D104 Field Service Manual page 527

1001 Bit Switch
005 Bit Switch 9
PDL Auto Detection timeout of jobs submitted via
USB or Parallel Port (IEEE 1284).
bit 0
To be used if PDL auto-detection fails. A failure of PDL autodetection doesn't necessarily
mean that the job can't be printed. This bit switch tells the device whether to time-out
immediately (default) upon failure or to wait 10 seconds.
bit 1 DFU
bit 2 Job Cancel
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might result in
problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
bit 3 PCL/PS bypass tray paper rotation (SEF/LEF)
This bitsw causes the device to revert to the behavior of previous generations. It only
takes effect if "Bypass Tray Setting Priority" = "Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the bypass
tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch, the MFP
will always prompt for paper of the rotation (SEF/LEF) determined by the MFP bypass
tray paper setting or by the bypass tray sensor.
Bit 4 DFU
to 7
1003 [Clear Setting]
Initialize Printer System
1003 1
Initializes settings in the "System" menu of the user mode.
1003 3 Delete Program
Main SP Tables-9
0 1
"Disabled
"Enabled
(Immediatel
(10 seconds)"
y)"
- -
Disabled
Enabled
(Not
(Cancelled)
cancelled)
0: Disable 1: Enable
- -
5
525