Ricoh D104 Field Service Manual page 768

3. Appendix: SP Mode Tables
1108 [After Reload/Job Target Temp.]
Center
001
Specifies the temperature of the heating roller after re-load or job.
Press (DFU)
Specifies the temperature of the pressure roller after re-load or job.
002
DFU
3
This SP is desgined for the factory use only. Do not change the adjusted setting.
[Environment Correction:Fusing] DFU
1111
These SPs are desgined for the factory use only. Do not change the adjusted setting.
Temp.: Threshold: Low
001
Specifies the threshold temperature for low temperature. If the fusing temperature is 17°C
or less, the machine executes the fusing mode for low temperature.
Temp.: Threshold: High
002
Sepcifies the threshold temperature for high temperature. If the fusing temperature is 30°C
or more, the machine executes the fusing mode for high temperature.
Low Temp. Correction
003
Specifies the additional temperature for the target temperature. If the fusing temperature is
in low temperature condition, this temperature is added to the taraget temperature.
High Temp. Correction
004
Specifies the additional temperature for the target temperature. If the fusing temperature is
in high temperature condition, this temperature is added to the taraget temperature.
Job Low Temp. Correction
005
Specifies the additional temperature for the target temperature when the environmental
condition is determined as low temperature.
006 Job High Temp. Correction
Specifies the additional temperature for the target temperature when the environmental
condition is determined as high temperature.
007 Job Low Temp. Correction:Sp. *ENG
50
*ENG [120 to 150 / 130 / 1 deg/step]
*ENG [0 to 200 / 5 / 1 deg/step]
*ENG [0 to 100 / 17 / 1 deg/step]
*ENG [0 to 100 / 30 / 1 deg/step]
*ENG [0 to 15 / 5 / 1 deg/step]
*ENG [0 to 15 / 0 / 1 deg/step]
*ENG [0 to 100 / 5 / 0.1 deg/step]
*ENG [0 to 100 / 0 / 0.1 deg/step]
[0 to 100 / 10 / 0.1 deg/step]