Ricoh D104 Field Service Manual page 52

2. Installation
• 4) Close the ARDF or the platen cover.
• 5) Press "Start Scanning" on the LCD panel. The machine starts the ACC.
6. Check that the sample image has been copied normally.
7. Open the front cover.
2
8. Remove the instruction guide sheet [A], and make sure the SMC report [B] is stored as shown above.
Then replace the instruction guide sheet.
Settings Relevant to the Service Contract
Change the necessary settings for the following SP modes if the customer has made a service contract.
• You must select one of the counter methods (developments/prints) in accordance with the contract
( SP5045-001).
Counting method
SP No.
SP5-045-001
A3/11" x 17" double counting
SP No.
SP5-104-001
Service Tel. No. Setting
50
Function
Specifies if the counting method used in meter charge
mode is based on developments or prints. NOTE: You
can set this one time only. You cannot change the
setting after you have set it for the first time.
Function
Specifies whether the counter is doubled for A3/11"
x 17" paper. When you have to change this setting,
contact your supervisor.
Default
"0": Developments
Default
"No": Single counting