Chrysler 2005 Crossfire SRT6 Service Manual page 340

5 - 174 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1110-RIGHT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE OF THE RIGHT FRONT WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance between ground and the Right Front Wheel
Speed Sensor Signal circuit.
Is the resistance greater than 300 ohms?
Yes >> Go to 10
No >> Replace the Right Front Wheel Speed Sensor. (Refer to 5
- BRAKES/ELECTRICAL/FRONT WHEEL SPEED SEN-
SOR - REMOVAL).
Perform ABS VERIFICATION TEST.
10.
MEASURE THE RESISTANCE OF THE RIGHT FRONT WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Right Front Wheel Speed Sensor Signal
circuit from the CAB harness connector to the Right Front Wheel
Speed Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 12
No >> Repair the Right Front Wheel Speed Sensor Signal circuit
for an open.
Perform ABS VERIFICATION TEST.
ZH