Chrysler 2005 Crossfire SRT6 Service Manual page 323

ZH
1100-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE OF THE LEFT FRONT WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance between ground and the Left Front Wheel
Speed Sensor Signal circuit.
Is the resistance greater than 300 ohms?
Yes >> Go to 10
No >> Replace the Left Front Wheel Speed Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR
- REMOVAL).
Perform ABS VERIFICATION TEST.
10.
MEASURE THE RESISTANCE OF THE LEFT FRONT WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Left Front Wheel Speed Sensor Signal
circuit from the CAB harness connector to the Left Front Wheel Speed
Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 12
No >> Repair the Left Front Wheel Speed Sensor Signal circuit
for an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 157