ZH
1035-CAN COMMUNICATIONS - NO MESSAGE FROM STEERING ANGLE SENSOR (CONTINUED)
3.
MEASURE STEERING ANGLE SENSOR FUSED IGNITION SWITCH OUTPUT CIRCUIT VOLTAGE
With the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
Steering Angle Sensor harness connector.
Is the voltage above 10 volts?
Yes
>> Go to 4
No
>> Repair the Fused Ignition Switch Output circuit for an
open.
Perform ABS VERIFICATION TEST.
4.
MEASURE THE STEERING ANGLE SENSOR SIGNAL CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Yaw Rate/Acceleration sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Steering Angle Sensor Signal circuit
from the Yaw Rate/Acceleration sensor harness connector to the
Steering Angle Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Go to 5
No
>> Repair the Steering Angle Sensor Signal circuit for an
open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 137