Chrysler 2005 Crossfire SRT6 Service Manual page 302

5 - 136 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1035-CAN COMMUNICATIONS - NO MESSAGE FROM STEERING ANGLE SENSOR (CONTINUED)
Diagnostic Test
1.
CHECK STEERING ANGLE SENSOR SIGNAL VOLTAGE
Note: Inspect Fuse 14 located in the Underhood Accessory Fuse
Block. If the fuse is open, repair the cause of the open fuse
before continuing.
Turn the ignition off.
Disconnect the ESP Yaw Rate/Lateral Acceleration Sensor harness
connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Steering Angle Sensor Signal circuit at the
ESP Yaw Rate/Lateral Acceleration Sensor harness connector while
slowly rotating the steering wheel from the full right position to the full
left position.
Note: It may be helpful to raise the front wheels off the ground
and support the vehicle using appropriate safety measures.
Does the voltage vary between 7.0 and 9.5 volts?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Go to 2
2.
MEASURE STEERING ANGLE SENSOR FUSED B(+) CIRCUIT VOLTAGE
Turn the ignition off.
Disconnect the Steering Angle Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the Steering Angle
Sensor harness connector.
Is the voltage above 10 volts?
Yes >> Go to 3
No >> Repair the Steering Angle Sensor Fused B(+) circuit.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH