Chrysler 2005 Crossfire SRT6 Service Manual page 299

ZH
1028-TCM NOT IDENTIFIED OR INCORRECT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: If the Controller Antilock Brake (CAB) cannot recognize the Transmission Control Module (TCM)
message, the DTC is set.
CONTROLLER ANTILOCK BRAKE (CAB)
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Turn the ignition on.
With the DRB III , erase DTCs.
Turn the ignition off.
Turn the ignition on.
Start the engine.
CAUTION: Ensure braking capability is available before road test-
ing.
Drive the vehicle above 16 km/h (10 MPH) for at least 20 seconds.
Stop the vehicle.
With the DRB III , read DTCs.
Does the DRB III
DTC?
Yes >> Replace the Controller Antilock Brake (CAB) Module. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/CONTROLLER ANTILOCK BRAKE - REMOVAL).
Perform ABS VERIFICATION TEST.
No >> The condition that caused this DTC to set is currently not present.
Perform ABS VERIFICATION TEST.
display a TCM Not Identified or Incorrect
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 133
POSSIBLE CAUSES