Chrysler 2005 Crossfire SRT6 Service Manual page 325

ZH
1100-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
13.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the related wiring harness and connectors. Look for any chafed, pierced, pinched, or partially bro-
ken wires. Look for broken, bent, pushed out, or corroded terminals.
Visually inspect the Left Front Wheel Speed Sensor, connector and tone wheel for damage and correct installation.
Are there any visible Sensor, connector or tone wheel concerns?
Yes >> Correct the sensor, connector or tone wheel concerns as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 14
14.
MONITOR ALL WHEEL SPEED SENSORS WITH THE DRB III
With the DRB III , erase DTCs.
Start the engine.
With an assistant to drive, use the DRB III to monitor all wheel speed
sensors. Slowly accelerate as straight as possible from a stop to 24
km/h (15 MPH).
Is the Left Front Wheel Speed Sensor Signal 0 or differing from
others by more than 5 km/h (3 MPH)?
Yes >> Replace the Left Front Wheel Speed Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR
- REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Inspect and repair the related wiring harness for a possible
intermittent condition.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 159